1. Disinfection of the device: Instrusol® and water, NeedlingPen needle head
2. Clean face and disinfect with Alcoderm
3. Spread sterile serum on face
4. Microneedling with technique
5. DERMAID Skin Plus Treatment PostBalm
6. Rinse dermaroller and disinfect with Instrusol®
7. Allow dermaroller to air dry and store in container
8. Avoid touching the skin, heavy sweating, steam baths and direct sun exposure
9. Do not wear make-up
10. Sleep is the best rest, change pillowcase if needed
Clean your device first. Mix 4 ml Instrusol® with 100 ml water in a glass and place the dermaroller in it for 15 minutes.
The needle roller should be completely covered with the mixture. Then rinse the dermaroller with lukewarm water and let it air dry.
If you are using the NeedlingPen instead, disinfect the needle head in the same process. After that, clean your face well and disinfect it with Alcoderm.
Then take the sterile serum with the syringe provided and spread it over your face. Wearing powder-free nitrile gloves is recommended to prevent the spread of germs.
Microneedling with the right technique - Technique is key. Here it is helpful to divide your body into different areas. Now roll 8 times from top to bottom and 8 times from left to right. Then 8 times diagonally from top left to bottom right and 8 times diagonally al from top right to bottom left. Between each roll, lift the dermaroller completely off the skin and replace it. Repeat this process until all areas of skin have been treated. If using the NeedlingPen, simply glide over the same area of skin 3-4 times.
After treatment, rinse the Dermaroller thoroughly with clean water and then disinfect it again with Instrusol® and water and allow it to air dry.
Store the dermaroller in the container provided. Avoid touching your skin with your hands for the next two hours. Avoid heavy sweating, steam baths and direct sunlight on the day of treatment.
Do not wear makeup. Sleep is the best rest for your skin now, and change your pillowcase if needed.